Golf III/Jetta III ‘93-’99 & Cabriolet ‘95-’02

CYLINDER HEAD 2.0 L

4 CYLINDER

1. Cylinder Head, complete w/ valves & cam.

     Remanufactured #SN16886 . .$429.95

     Recycled#SN39056 . . . . . . .$275.00

2. Valve cover gasket

     #SN14512 . . .$16.95

3. Head bolts (set of 10) You MUST replace these every time!

     #SN12306 . . . . . . . $19.95

4. Oil baffle #SN1196 . . .$19.95

5. Valve cover hold-down strip

     #SN38985 . . . . . . . . .$5.00

6. Valve cover REC #SN38984 . .$20.00

7. Oil filter cap #SN5029 . . . . .$3.95

8. Upper intake gasket (Replace every time! This is a common source of vacuum leaks)#SN17234 . . . . . . . .$6.95

9. PCV valve#SN16885 . . . .$42.95

10. Grommet (holds PCV)

     #SN11775 . .$2.97

11. Breather hose from crankcase to PCV valve

     #SN16991 . . . .$39.95

12. Head gasket #SN15609 . . .$39.95

     Head gasket set (all gaskets)

          #SN17994 . . .$79.95

This sensor (actually a small variable resistor) tells the Motronic Injection brain how far you’ve opened the throttle. If it fails, the brain gets the wrong signal or no signal at all. It’s easy to test with an ohmmeter and a Bentley Manual. If yours is bad, get the part number off yours before you call, there are many different ones with different plugs on them. Starting at $40.00.

CYLINDER HEAD VR6

Remanufactured #SN38006 . .$$695.00

2. Valve cover gasket

     ‘92-95.5 #SN11527 . . . . .$12.95

     ‘95.5-99.5 #SN15553 . . . $18.50

3. Head bolts (set of 20) You MUST replace these every time! #SN18744 . . .$69.95

4. Valve cover Recycled

     ‘92-95.5#SN38986 . . . . .$50.00

     ‘95.5-99.5 #SN38987 . . . .$50.00

5. Oil filter cap #SN5029 . . . . .$3.95

6. Tensioner, Serpentine Belt

     #SN16658 . . . . . . .$149.95

7. Head gasket #SN11526 . . .$39.95

8. Head gasket set (all gaskets)

     #SN12247 . . . . . . . . . .$149.95

9. 9.Coil pack ‘94-99.5
   

     #SN16796 . . .$425.95

The throttle body itself doesn’t “fail”, but over a long period of time, it may become gummed up or worn out. The part of the throttle body that fails is the throttle position sensor. On cars built before 1996, the sensor can usually be replaced separately, but on the 1996 and later cars, you have to replace the entire throttle body. Please have the part number off yours before you call as there are many variations. The part# should begin with 037- if you have a 4-cylinder car or 021- if you have a 6-cylinder car.

NEW TDI ENGINES

CYLINDER HEAD TDI

     New #SN18654 . . .Call

     Remanufactured #SN39646. .$695.95

     Recycled#SN38989 . . .$595.00

2. Valve cover gasket #SN15588 . .$18.95

3. Head bolts (set of 10) (Stretch bolts - they MUST be replaced every time!)

     #SN15551 . . .$28.95

4. Valve cover (NEW!) #SN18757 . .$69.95

5. Valve cover attachment hardware (3 studs & 3 grommets)

     #SN16712 . . .$5.99

6. Oil filter cap #SN5029 . . .$3.95

7. PCV valve#SN18758 . . .$43.95

8. Grommet for PCV valve

     #SN11775 . . .$2.97

9. Breather hose from crankcase to PCV

     #SN18760 . . .$49.95

10. Head gasket

     1 notch #SN18629 . . .$45.95

     2 notch #SN18630 . . .$45.95

     3 notch #SN18631 . . .$62.95

11. Camshaft seal #SN1143 . . .$3.95

Sometimes called a “mass air sensor” the airflow meter can be contaminated by oil or soot in the intake air, or the film can burn off. Without an accurate measure of intake air, the engine will run poorly or not at all. We have most airflow meters available new or recycled. Call for availability.

2.0L 4 cylinder

‘93-95

NEW #SN15479 . . . . . . .$379.95

Recycled #SN36706 . . . .$250.00

‘96-99.5

NEW #SN18316 . . . . . . . $349.95

Recycled #SN38035 . . . . $149.00

2.8L VR6

‘94-95

NEW #SN18069 . . . . . . . .$349.95

Recycled #SN38990 . . . . .$250.00

‘96-99.5

NEW #SN15480 . . . . . . .$359.95

Recycled #SN15481 . . . .$289.00

TDI

‘96-99.5

NEW #SN18380 . . . . . . .$289.95