HEAVY-DUTY SPRINGS
The Rabbits, Sciroccos, Golf and Jetta have all suffered from poor springs, particularly the early models. Stock springs on Rabbits, Sciroccos, and Jettas are a little weak for any of these conditions: hard driving, gravel roads, a two-hundred pound carpenter's tool box, or four two-hundred pound adults. If you regularly drive under these conditions or you are not satisfied with too frequent "bottoming out," then our heavy-duty springs are the ticket. The sets we sell are the heaviest "almost standard" sets on the market. They are U.S. made by a major manufacturer of suspension products. Quality is first-class.
The springs are standard height, progressive rate (which means as the spring is compressed, the rate of load which you can carry increases), and approximately twenty percent stiffer than the highest rate and heaviest factory GTI spring. With these springs installed your car will ride a fraction of an inch higher than stock, and, as they are progressive, the spring rate the local carrying capacity actually increases as the car is loaded. As a bonus, the car will have GTI-like handling.
DESCRIPTION_____PART #_____PRICE
Jetta/Rabbit ‘75-‘84, Scirocco thru ‘88, Cabriolet thru ‘93
Front #SN11065 Pair . . .$94.98/pr
Rear #SN2143 Pair . . .$94.98/pr
Both for #SN11626 save -40.00
Golf/Jetta ‘85-’92
Front #SN1977 Pair . . .$94.98/pr
Rear #SN2144 Pair . . .$94.98/pr
Both for #SN11626 save -40.00
Golf/Jetta ‘93-96.5 4-cylinder only
Front #SN18184 . . .$94.95/pr
Rear #SN18183 . . .$94.95/pr
Both for #SN11626 save -40.00
Golf/Jetta ‘96-99.5 4-cylinder only
Front #SN16580 . . .$69.99/ea
Rear #SN18183 . . .$94.95/pr
SPRING COMPRESSOR
We sell a spring compressor tool; it's not U.S. made, but it works and will last for 100 spring jobs. It's plenty strong enough for VW® springs, a little weak for Ford Truck springs. It's low price can fool you. Follow the directions.
Spring Compressor Set
#SN03530 . . . . . .$19.95